Complete Insulation Solutions for Every Building Type

Surface Preparation & Deep Cleaning

Remove dust, grease, rust and any loose old layers. Use compressed air or wire brush depending on surface type. A clean surface ensures proper adhesion of subsequent materials.

• Remove rust from sheet metal with wire brushing or chemicals
• Eliminate any weakly adhered old coatings
• Inspect joint and fixing points

Treat Sensitive Points & Joints

Apply specialised sealant to fixing points, joints and corners before general application. These spots are most prone to leaking.

• Fill sheet metal joints with specialised sealer
• Treat screw heads and fixing points
• Reinforce corners with appropriate filler

Foam Base Coat (Levelling Layer)

Apply a thin initial layer of low-density foam to level the surface, fill minor details and create a uniform base for the main layer.

• Base coat thickness: 12 cm
• Low density 1520 kg/m
• Fills gaps and small joints

Main Foam Layer at Required Thickness

Spray foam with high-pressure equipment at the specified thickness based on project requirements and objectives. Thickness determines thermal insulation coefficient and compression resistance.

Acrylic Paint (UV Protection Layer)

Foam alone degrades under UV rays within 12 years acrylic coating is mandatory to protect the foam and multiply its lifespan.

• White or light grey acrylic to reflect sunlight
• Applied in two coats: first after 24h from spraying, second after first coat dries
• Total coat thickness: 0.30.5 mm
• Aluminised reflective additive for higher thermal performance

Geotextile Layer (Non-Woven Fibres)

Embedded in the acrylic layer to reinforce the foam surface and resist cracking from thermal expansion and mechanical abrasion.

• Fibres spread over first acrylic coat before it dries
• Covered by second acrylic coat to lock them in
• Increases surface durability 34 times
• Suitable for roofs where people or light equipment may walk

Final Inspection & Documented Handover

Full surface inspection after curing, adhesion testing, complete photo documentation, then handover with warranty certificate.

• Comprehensive visual inspection of all roof areas
• Before & after photo documentation
• Warranty certificate delivery